Gluing the panels inside

Today dad has been busy gluing the inner joints of the boat with epoxy and fiberglass. Lots to do to make the interior of the hull completely watertight and strong.

trying hard not to step on wet glue

front part ready for epoxy

Adding epoxy to the fiber

Cutting out Bulkhead with Dremel

Today a small work with a huge importance was done. We cut out the Bulkheads' shape for the passageways inside of the boat.

The first stowaway of Serenite.

Sultan discovering the sanded inside of the boat

First Bulkhead is cut.

Our Dremmel, our transformer and our vacuum cleaner.

Staying on the line

Moments of high concentration

verifying the drawn lines

almost done

straight lines

last straight line

Building a ladder to get into the boat and sanding the inside

(Written : Sultan)
First day of work for dad without me as I have now resumed studies at University.

He built himself a big ladder from our jig-wood. The ladder will allow anyone to get into the boat to work inside of it without having to climb onto the thin edges where the fiberglass can easily hurt anyone until it is sanded smooth.

Only one way to quickly and efficiently polish a piece of dry epoxy glue. We use a small drill and a circular sand-paper adapter on it. It is in fact so efficient that in numerous cases we have had to add glue again onto the sanded area because excess fiberglass and glue had been removed.

Dad and his new ladder

inside of boat sanded

Add caption

Edges now smooth

Sides very smooth

Building a table-saw and photos of boat now upright

For the outer edges of Serenite's hull we're going to place long strips of wood called "gunwales". Thus, we will have to cut them to the proper dimensions and, for that, we built ourselves a table-saw from a sheet of marine plywood and our dangerous Circular Saw that we almost never use because of the risks involved.

We've even tested it with a big piece of wood and cut a thin strip from it.

The table built in about 5 minutes with our cordless electric screw drivers.

just added the circular saw to the table.

The Blade

Circular saw firmly fixed

the exit for wood dust can later be used to collect wood flour

extra support for the engine

our big log and its thin strip

Then we removed the cover of the boat and took some pictures of it upright.

Serenite Upright

looking wide and spacious

untreated inside part of the nose

already looking ready for the sea

the "bearded" captain

protection against sunlight 

completely covered up

Turning Boat upright

With help from my neighbour and his sons, we quickly turned the boat over onto its hull. Now its looking beautiful upright. Pictures will be coming along by tomorrow night.

First bath of Serenite and more sanding

Today in the early morning, Serenite got her first bath. Since we have now finished with placing the fiberglass, the boat is entirely plastic-like on the outside and can be washed with a water hose.

In the afternoon, we sanded her again to remove any kind of roughness off her skin and then applied a last layer of epoxy glue leaving her with a shiny and smooth finish.

Now we're planning to turn her upright again during the weekend and then start with her interior during next week.

Epoxy boat building : If you're not sanding, you're not doing it right!

Today........we sanded.....and sanded the boat again.

We actually started the day by going to Amro Chemicals again to buy a new stock of epoxy and hardener. On reaching home, we sanded the outer hull again as we wanted to add one last of glue to make it smooth so that marine life won't be able to hold on to it. Before sanding, the hull was shiny but had some rather jagged edges where layers of fabric met. Now it is all smooth and waiting for our last layer of glue. We will put it early tomorrow morning.

Only half sanding done in this picture.